Robustel R3000 User Guide Manual do Utilizador descarregar pdf (Página 128)

Robustel GoRugged R3000 User Guide

RT_UG_R3000_v.2.0.0 17.01.2014 127 / 131

Confidential

5.2 How to configure the CLI

Following is a list about the description of help and the error should be encountered in the configuring program.

Commands /tips

Description

you the help information.

Ctrl+c

Press these two keys at the same time  

.



are not supported by the system, in this case, enter a mark

   about this

issue.

Incomplete command

Command is not incomplete.

% Invalid input detected at '^' marker

'^' marker indicates the location where the error is.

Note: Most of the parameters setting are in the Global configuration mode. Commands set ,add are very important

for this mode. If some parameters can’t be found in the Global configuration mode, please move back to Privileged

exec mode or move up to Interface mode.

Note: Knowing the CLI hierarchy level modes is necessary before configuring the CLI. If not, please go back

and read it quickly in chapter 5.

5.2.1 QuickStart with configuration examples

The best and quickest way to master CLI is firstly to view all features from the webpage and then reading all CLI

commands at a time , finally learn to configure it with some reference examples .

Example 1: Show current version

R3000> show version

software version : 1.01.00

kernel version : v2.6.39

hardware version : 1.01.00

Example 2: Update firmware via tftp

R3000> enable

Password: *****

R3000#

R3000# tftp 172.16.3.3 get rootfs R3k.1.01.00.02_130325

Tftp transfering

tftp succeeded!downloaded

R3000# write //save current configuration

1 2 ... 123 124 125 126 127 128 129 130 131 132

Sem comentários

Robustel R3000 User Guide Manual do Utilizador Página 128