
Robustel GoRugged M1000 Pro V2 User Guide
RT_M1000 Pro V2_UG_v01.00 23.11.2012 33 / 49
Confidential
Tick the Time checkbox to allow gateway automatic connects to
GPRS/UMTS with preset time schedule every day, support maximum 3
time schedule/day (e.g. 07:00, 11:00 and 23:30 every day).
Tick the Periodically Connect Interval checkbox to allow gateway
automatic connects to GPRS/UMTS with preset interval, select from 1
to 1800 minutes. The interval is defined as time interval between two
GPRS/UMTS connections.
Tick the Call checkbox to allow gateway automatic connects to
GPRS/UMTS with incoming call from specified Caller ID (phone
number).
Set the Phone Group which was allowed to wake up the gateway by
call.
Tick the Enable SMS Reply checkbox to allow gateway send reply short
message after automatic connects to GPRS/UMTS by Call Wakeup
from specified Caller ID (e.g. GPRS on ok!).
Note: Only support text format SMS.
Tick the SMS checkbox to allow gateway automatic connects to
GPRS/UMTS with incoming specified short message from specified
Caller ID (phone number).
Specified short message is set at Password item. (e.g. GPRS on)
Set the Phone Group which was allowed to wake up the gateway by
SMS.
The specified short message which was used to wake up the gateway
Tick the Enable SMS Reply checkbox to allow gateway send reply short
message after automatic connects to GPRS/UMTS by SMS Wakeup
from specified Caller ID (e.g. GPRS on ok!).
Note: Only support text format SMS.
Tick the Serial Data Wakeup checkbox to allow gateway automatic
connects to GPRS/UMTS from idle mode when there is data come out
from serial port.
Output (0x) to COM
port after online
After input the value in the field, gateway will output a command with
hex format to gateway serial port when it has been wakeup from idle
mode.
Maximum 30 bytes.
Note: supports all wakeup modes.
Note:
1. Time format for Time reboot is 24-hours.
2. The phone numbers for Call and SMS function can be set in Phone Book tab.
3. The Caller ID must be written in international format, starting with “+” followed by the country code.
Comentários a estes Manuais